Turning Tool Set with Aluminum Handle

Turning Tool Set with Aluminum HandleThis turning tool set includes 4 interchangeable 170 mm long steel tool shafts, with square, curved, round and diamond parting shaped carbide cutters. The 270 mm long aluminum handle has a collet that allows the cutters to be quickly changed out. When the carbide cutters start to get dull, they can be rotated to expose a fresh cutting edge. Once all the available cutting surfaces on a carbide insert are dull, it is possible to resharpen them using a

It works very well for final shaping where a good finish is required

Although these sharpening stones don't need to be flattened as often as waterstones

We only stock the 22 inch length

They are built to the same high quality standard as the Narex Richter Bench and Mortise chisels:

SPECIFICATIONS

5 mm thick

The tapered bit acts as both a pilot bit and drill bit and is machined with elongated flutes for fast and clean chip clearance

either by trial and error

20 mm and 26 mm widths

00028") for the angle along the entire length of the square

Cork Liners for HNT Gordon Front Vises and Pattern Makers Vises:

Weighs in at 3