DroMight™ Talon V1 Drop System For DJI Matrice 300 Series

DroMight™ Talon V1 Drop System For DJI Matrice 300 SeriesThe DroMight Talon V1 is the ultimate drop system for the DJI Matrice 300 RTK and is also compatible with the DJI Matrice 350RTK. This modular system allows the operator to quickly install and uninstall the Talon drop system in less than 30 seconds. This simple solution uses a light sensor pod placed over the strobe light located on the bottom of a Matrice 300RTK or the Matrice 350RTK. When operating the aircraft's smart controller, you can remotely

allowing you to capture stunning aerial footage with ease

Matrice 350 RTK

which run different firmware even though the physical model number is similar

It installs easily with prealigned factory mounting points

The GL10 is sized for the smaller Mavic 3 Enterprise platform — just 150 g and 28 W — and is spotlight + flasher only

Actual flight time varies slightly across the three compatible airframes (the lighter Mini 3 typically squeezes out a couple of extra minutes vs

6 batteries

Connect it to a 100 W USB-C power source and the hub charges up to three batteries back-to-back from highest state of charge to lowest

and more immersively — right out of the box

DFR programs standardized on the Mavic 3 Enterprise platform that need a night-operations payload without stepping up to the larger M300/M350 + LP35 stack

Padlock-ready: padlock holes are reinforced with stainless steel padlock protector clips

Can I leave the guards installed when packing the aircraft